Setup guide

– 3.7 –
• The loaded ink
cartridge is defective.
• The ink cartridge is
not attached to the ink
station.
•The preheater or print
heater has failed.
• The power of heater
is off.
• The printheater is
disconnected.
• The operating voltage is
100 to 200 VAC but the
voltage selector of the
heater is set to 220 V.
• The preheater is
disconnected.
• The operating voltage is
100 to 200 VAC but the
voltage selector of the
heater is set to 220 V.
• The thermistor of the
preheater is defective.
• The thermistor of the
printheater is
defective.
1) Check the loaded ink cartridge.
1) Attach the ink cartridge(s)
corresponding with the color shown
on the display.
1) Press the [HEATER] key to display
the details of the error. Check the
error.
1) Turn on the power of the heater.
1) Set the voltage selector to the correct
voltage.
2) Replace the printheater.
3) Replace the fuse if blown.
1) Set the voltage selector to the correct
voltage.
2) Replace the preheater.
3) Replace the fuse if blown.
1) Replace the thermistor.
2) Replace the IO2 PCB.
3) Replace the main PCB.
Message Description
Corrective measures and
recovering procedures
WRONG CARTRIDGE
KMCYmc
NO CARTRIDGE
KMCYmc
<LOCAL> ! HEATER
width: xxxxx mm
∗ REMOTE ∗ ! HEATER
TYPE. 1 0.0 0 m
Heater Power OFF
Pre 40° 45° C
Print BREAKAGE
Pre 55
o
C (40)
Print THERMISTOR
Pre BREAKAGE
Print 43° C ( 4 7)
Pre THERMISTOR
Print 50
40
o
C