Setup guide

– 1.9 –
Print Resolution of JV3 series and Notes on specified media.
Resolution Notes / Limitations Media
360 x 360 • Basically, 360 x 360 dpi is not recommended.
• In the 360 dpi mode, the dot diameter is small and therefore
the density is low and banding is remarkable.
360 x 540 • Use for high-speed output applications is recommended.
• 6-pass specification or higher is recommended.
In the 6-pass specification or higher mode, the amount of feed
is small and the accuracy improved, allowing banding to be
reduced by software processing.
In addition, good fixing and drying characteristics can reduce
banding caused by beading.
720 x 720 • Basically, 720 dpi is recommended.
• 8-pass specification or higher is recommended.
In the 8-pass specification or higher mode, the amount of feed
is small and the accuracy improved, allowing banding to be
reduced by software processing.
In addition, good fixing and drying characteristics can reduce
banding caused by beading.
• If the desired density cannot be obtained, double painting is
recommended.
•PVC glossy : 16 pass
•PVC mat : 8 pass
•PVC mat : 16 pass
• FF : 8 pass
•Tarpaulin : 8 pass
•Tarpaulin
(For draft purpose)