Setup guide

– 5.55 –
a. SDRAM check
1) The indication “SDRAM” is shown on the
LCD.
Press the
ENTER
key.
2) Use the
and keys to set the waiting
time after data have been written in until the
read-in check is performed .
OFF : With WAIT time
ON : Without WAIT time
3) When the
ENTER
key is pressed, the check
starts.
The number of checks are shown on the LCD.
(Single check takes about 10 minutes.)
When an error arises, the error address will appear
on the LCD. At this time, if the
key or the
key is pressed, read/write data and number
of checks until error occurrence will be displayed.
4) Press the
key to terminate the
SDRAM checking.
# MEMORY check
CHECK : SDRAM
# MEMORY check
WAIT TIME : OFF
# MEMORY check
CNT : 1 SDRAM
# MEMORY check
E h’ ac 400000 (M)
# MEMORY check
ER : ∗ ∗ h W : ∗ ∗ h
# MEMORY check
COUNT = ∗ ∗ ∗