Setup guide

– 5.10 –
1) Select the “Adjust : FINE”.
Press the
ENTER
key.
2) Select the adjustment item using the
or
key.
Press the
ENTER
key.
3) Select the color to plot.
Move the cursor using the
or key and
then select the plot color.
Select whether the selected color is plotted or not
using the
or key.
4) Start plotting with the
ENTER
key.
(Plot length: about 25 mm; plot width; paper
width)
If “Y Single” has been selected )
Input the correction value for the Y forward
using the
or key.
Enter the correction values between heads 1 and
2, and between heads 1 and 3.
.
If “Y Repeat” has been selected )
Input the correction value for the Y repeat
travel using the
or key.
Enter the correction values between heads 1 and
2, and between heads 1 and 3.
#PRN. adjust2 V2
Adjust : FINE
#PRN. adjust2 V2
FINE : Y Si.
#PRN. adjust2 V2
FINE : Y Re.
#PRN. adjust2 V2
FINE : Y Bi.
#PRN. adjust2 V2
COLOR : KCm
#PRN. adjust2 V2
FINE : Y Si.
#PRN. adjust2 V2
Y Si. 1-2 : 0.0
#PRN. adjust2 V2
Y Re. 1-2 : 0.0