Specifications

- 5.3 -
Setup functions
The following describes the overview of and settings for each function.
Name Function
STATION Clean the inside of the station, ink discharge way and replace the wiper.
(CARRIAGEout, WIPER EXCHANG, NOZZLE WASH, Disway WASH, CUSTODYwash)
PRINT ADJUST Adjust the dot position according to the head height, thin/thick.
INT.WIPING Wipe off the condensed ink.
ROUTINE CLN Perform head cleaning and flushing operation at intervals while main unit is
turned on and waiting operation.
SLEEP clean Perform head cleaning and flushing operation to prevent from nozzle-out
phenomenon.
FILL UP INK Perform this function if nozzle clogging is resolved after head cleaning.
HEAD WASH Perform this function if nozzle clogging is resolved after head cleaning.
SCAN WIDTH This is not normally used.
LIST Plotting the set condition of the device.
DATA DUMP Plotting data commands received from the computer, in HEX code.
WIPE LEVEL Makes setting to move up the wiper replacement warning depending on the
operating environment.
TIME SET Sets the date and time of the built-in calender of the device.
INFORMATION Displays the firmware version, serial number, and dealer number of the
device.
page 5.4
through 5.10
page 5.12
page 5.14
page 5.16
page 5.17
page 5.18
page 5.18
page 5.20
page 5.21
page 5.22
page 5.23
page 5.24
page 5.25