Specifications

- 4.9 -
MARGIN P. A.6
This function sets a dead space to increase/decrease the right and left margins of the
media.
The function is used to increase the margin for binding.
You can set a dead space for each of the right and left margins of the media.
(-10-85 mm)
COLOR PATTERN P. A.7
Plots a color pattern at the right end of the media. Nozzle clogging can be checked
during plotting.
When color pattern is ON, plotting start position glides 18mm from the origin to the scan
direction. The plotting working width becomes smaller. Therefore, when plotting is made
all the way to both ends of the media, turn this function off.
Origin
18 mm
REFRESH P. A.7
Solidification of ink can be prevented by refreshing the head during plotting.
If this function is executed in a dusty place or dry place, ink in the head will be likely to
solidify.
A larger level results in more number of refreshes.
(LEVEL0-3)
DATA
PRE-FEED P. A.6
Media that require high heater temperature for plotting, or other types of media that
have a soft surface causes following problem.Media may stick to the platen if left on
the platen.Media rise from the platen and causes media jam.
In this case, set PRE-FEED to ON. Prefeed function works automatically to prevent the
media from sticking to the platen by feeding the media to back and forth before start
plotting.
(ON, OFF)