Specifications

- 2.29 -
When [NEAR END] or [INK END] appears
If ink in the cartridge comes to an empty, the corresponding message appears.
Plotting can be continued but ink may run out during plotting.
Immediately put a new ink cartridge.
•In case [NEAR END] is indicated on the LCD, replace a ink cartridge in good
time. When carrying out continuous output, after checking the ink level, start
printing. In case ink finish, printing stops, or replacing the ink may result in
color change during printing.
NEAR END
When the amount of ink becomes small during plotting
Indicate the ink color which has run out.
The display at right indicates that black ink comes to an end.
INK END
When the amount of ink completely runs out during plotting
Indicate the ink color which has completely run out.
The display at right indicates that magenta ink runs out.
STEPS:
1. Either of the messages shown above is dis-
played on the LCD during plotting.
• When [NEAR END] appears, the local mode is resumed
and the operation stopped each time plotting of a single
data is completed. Proceed with Step 2 at the end of the
plotting operation. Proceed to Step 2 at the end of the
plotting operation.
• When [INKEND] appears, plotting cannot be continued.
2. Install a new ink cartridge.
Pull out the ink cartridge of the indicated color and then set a
new ink cartridge.
The device enters the LOCAL mode.
Continuous plotting is possible.
Display ink information
This information allows you to check the remaining amount of ink.
1. Press the [ENTER] key in the LOCAL mode.
The remaining amount of ink is displayed with a number.
1 indicates near end and 9 full.
Also you can check the ink type filling up now.
2. Press the [ENTER] key.
The menu returns to the LOCAL mode.
If the ink cartridge is defective, the error details are displayed.
P.6.6, 6.7
< LOCAL >
NEAR END K - - -
< LOCAL >
INK END - - C -
NEAR END FULL
1 2 3 4 5 6 7 8 9
SS2-INK K M Y C
REMAIN 9 8 7 8