Specifications

- 2.22 -
If a failure occurs...(Cleaning)
STEPS:
1. Press the [TEST&CLEANING] key twice.
2. Press the Jog key [
] or [ ] to select the type
of cleaning.
soft : Select this if there is any missing line.
normal : Select this if any line is bent.
strong : Select this if inferior plotting cannot be
recovered after [normal] or [soft] cleaning.
4. Press the [ENTER] key.
Cleaning starts.
The operation status is displayed as * in the second line.
The device revert the LOCAL mode.
5. Repeat steps 2, and check the result of the test
plotting.
Repeat steps 1 to 3 until normal plotting result is obtained.
• If a normal test pattern cannot be obtained even after the cleaning function
is executed, clean the wiper and ink cap.
page.3.4
TEST &
CLEANING
CLEANING
TYPE : normal
CLEANING
TYPE : normal
CLEANING
TYPE : soft
CLEANING
TYPE : strong
CLEANING ACTIVE
∗ ∗ ∗ ∗ ∗ − − − − − − − − − − −
< LOCAL >
width : 1272 mm