Specifications

When media thickness is changed
4-16
7
Check the position where the drawn
pattern is in one straight line.
• In the case of the figure in the right, you will notice
that a straight line is formed at the point +140.
8
Adjust it by pressing or .
• Setting value : 0 to 400
• When there is no pattern forming a straight line between 0 and 400
(1) Once again, perform the checking of the head gap ( P.3-6 ).
(2) Perform the procedures from the Step 1.
9
Press the key.
10
Press the key three times to finish.
+ 100 + 200
PRN . a d j u s t
300dp i NORMAL : 0
PRN . a d j u s t
DPI : 300
ENTER
END