Specifications

4-4
Ink cartridge
Replacing with a new ink cartridge
Replacing of ink cartridges is required in the following cases.
Replacement of ink cartridges
Perform the replacement of the ink cartridges in the local mode or after cutting OFF the power supply
( P.2-15 ).
1
Remove an ink cartridge to be
replaced.
2
Set a new ink cartridge
• As shown in the drawing, set an ink cartridge
turning up a side containing the IC chip.
• Ink fill up starts.
Display on the screen Outline
Remaining amount of ink in an ink cartridge is few.
• Drawing can be continued, but running out of ink may occur during the drawing.
Earlier replacement is recommended.
• The display shown in the left indicates that magenta ink is few.
Ink in an ink cartridge is run out.
• Drawing can not be continued. Replace with new one immediately.
• The display shown in the left indicates that magenta ink is run out.
<LOCAL>
INK NEAR END:M______
<LOCAL>
INK END:M_______
IC chip