Specifications

4-2
Routine maintenance
Be sure to conduct maintenance works for the device depending on operation frequency or periodically so
as to use the device for a long time while keeping its drawing accuracy.
When the device is left unused for a long period of time
Notes on cleaning
• Be sure to turn off the main power switch on rear side of the device. ( P.2-15)
• Remove the media being set.
• Never disassemble the device. Disassembling the device can result in electric shock hazards
and breakage of the device.
• Prevent moisture from entering inside device. If the inner part of the device becomes wet,
electric shock hazards and breakage of the device can result.
• Conduct maintenance works after turning off the main power switch and detaching the power
cable. If not, unexpected troubles can arise.
• Make maintenance after the UV lamp has been sufficiently cooled, or burn injury may occur.
• Do not use benzine, thinner or chemical agents containing abrasives. Such materials can
deteriorate or deform the surface of the cover.
• Do not apply lubricating oil or the like inside the device. Such materials can cause the printer
mechanism to fail.