Specifications

Before taking a phenomenon as a trouble

5-3

In Case of Trouble

If image quality declines

Corrective measures against troubles in the case where satisfactory image quality is not provided are

described in this station.

Take measures in accordance with actual state of the picture.

If the measures fail restore the device to the normal state, contact your local MIMAKI distributor or MIMAKI

office call for service.

Resolving nozzle clogging

If nozzle clogging is not resolved even the head cleaning operation of P.2-10 has been executed, check the

following 2 items.

Fill ink with the operation of P.4-20.

Replace ink with the operation of P.4-4.

Stopping the unit during the operation

Press the EMERGENCY SWITCH for stopping the unit urgently

for the safety reason.

One EMERGENCY switch is placed on the front face of the unit

and 2 are placed on each of the back surface and Y-bar

respectively.

Development Corrective measure

Lines/thin spots are obvious occur (1) Execute the head cleaning. ( P.2-10)

(2) Clean the wiper and cap. ( P.4-26)

(3) If slip of paper is present in the head path, for example,

above the work plate, remove it.

Large ink drop on media (1) Execute the ink caps cleaning. ( P.4-26)

(2) Execute the head cleaning [normal]. ( P.2-10)

(3) Dust the media.

(4) Dust the table.

(5) Execute the cleaning for the undersurface of the

carriage. P.4-8

(6) Set a correct value to the head gap value.

P. 3- 7

Media is raised during printing and

printing stops.

*1. During printing, media may be raised due to the heat from the UV lamp, causing printing to be stopped.

(1) Set new media and start printing.