Instruction manual

- 5.10 -
7. Holding the projections at both ends, insert a
new wiper into place.
• Contacting the rubber portion of a new wiper
shall be avoided. It can cause the nozzle to be
clogged.
8. Clean the wiper guide shaft using a cotton bud
or cloth.
If dirt is hard to remove, use a cotton bud of cloth dampened
with water.
• Cleaning the wiper guide shaft.
(
page 3.7 )
Extremely dirty wiper guide shaft may cause
operation failure of the wiper, resulting in error
display.
9. Check the flashing tray ink absorber. Replace if
ink is found on the ink absorber.
(
page 3.12 )
10. Close the station cover, then press the [EN-
TER] key.
11. The machine enters the LOCAL mode.
Initialize
Please Wait
<< LOCAL >>
X =1010 Y = 1860