Instruction manual

- 4.4 -
Function mode
The FUNCTION mode enable to regists 4 types.
If the type has been registered for each medium type, it becomes easy to change plotting conditions
when the medium type is changed.
Registering a type
1. Make sure that the mode is LOCAL mode.
2. Press the [FUNCTION] key.
3. Press the [ENTER] key.
4. Select any of Types 1 through 4 by pressing
the JOG [ ] or [ ] keys.
5. Press the [ENTER] key.
Setting Printing Conditions.
(page 4.5 through 4.9)
Changing the type
If printing conditions for types 1 through 4 have already been registered, settings can be selected
according to the printing simply by selecting the type.
1. Perform steps 1 through 5 above.
Select a type.
2. Press the [END] key.
Printing with the printing condition registered for the selected
type is possible.
<< LOCAL >>
X =1010 Y = 1860
FUNCTION
SETUP < ENT >
SETUP
SELECT : TYPE1
SETUP
SELECT : TYPE1
Type1
Print Mode < ent >