Instruction manual

- 2.20 -
Displaying machine information
Displays the firmware version, ink level etc. This following describes the procedures to display the
machine in formation during printing or REMOTE and CYCLE mode.
••
••
• In LOCAL mode, information displays by pressing [ENTER] key as well.
STEPS:
1. Display the LOCAL mode.
2. Press the [REMOTE] key.
The machine enters the REMOTE mode.
3. Press the [ENTER] key to display the ink re-
mains.
4. Press the [ENTER] key to display the head
height.
5. Press the [ENTER] key to display the ink type.
6. Press the [ENTER] key to display the firmware
version and command.
7. The [ENTER] key displays setting status.
The [ ] key displays the in-use setup contents.
8. The [ENTER] key displays error information
guidance.
The [ ] key displays current warning.
9. Press the [END] key, the machine returns to the
REMOTE or CYCLE mode.
••
••
• Return to the REMOTE mode or CYCLE mode
automatically when the 60 seconds pass over
or error is occurred.
<< LOCAL >>
X =1010 Y = 1860
<REMOTE>
X=1010 Y=1860
Ink Level
3231798745990253
Head Height
∗ . ∗ mm
Ink Type
Type :TPig
Ver1.00 MRL-lIC
<REMOTE> TYPE ∗
X=1010 Y=1860
SETUP < TYPE ∗>
Display [
] Key
Error Info
Display [ ] Key