Instruction manual

- 2.13 -
Checking and solving nozzle clogging
STEPS:
1. The machine enters the LOCAL mode.
2. Press the [TEST] key.
3. Select from all head (L1234), ink head (L12 - - ),
or discharge head (L - - 34).
4. Press the [ENTER] key.
5. Select numbers to print.
6. Press the [TEST] key or [ENTER] key.
The machine prints the test pattern.
After the test print is done, the table moves to the front and
turns to LOCAL mode.
7. Check the test patterns.
If a failure occurs, proceed with step 8; otherwise, terminate
the operation.
If a failure occurs, perform the following operation
8. Press the [CLEANING] key.
9. Press the XY [
] or [ ] keys to select the head-
block for cleaning.
(Refer to page.1.11 [Ink station] )
10. Press the XY [ ] or [ ] keys to set on/off of the
blocks that need cleaning.
<< LOCAL >>
X =1010 Y = 1860
TEST PRINT
< ENT >
TEST PRINT
Head Line : L1234
L1234/L12 - -/L - - 34
TEST PRINT
Print Count = 1
<< LOCAL >>
X =1010 Y = 1860
∗ ∗ PRINT∗ ∗
Clean
:12563478
Select : ABEF- - - -
[1256ABEF] / [3478]
Clean :12563478
Select : ABEF- - - -
Clean
:12563478
Select : ABEF- - - -
On / Off