Instruction manual

- 2.9 -
Setting the work on the machine
Fixing the work holder
When printing on a material of allowable size (1870 x 1050mm maximum) that tends to bend
upward (floating at two or four edges), use the work holders on any of the four table edges
to fit the work in place.
STEPS:
1. Turn (or remove) the knob screws to loosen the
work holder.
A collar is fitted to each of the screws of the
work holder. Do not lose them when they are
removed.
2. The right and left work holders may be turned
upside down as needed according to the work
size.
3. Place the work between the work holder and
the table.
4. While pressing the work holder down, re-
tighten the knob screws.
Right and left work holders
(square C-shape)
Front and back work holders
(L-shaped; cannot be turned
upside down)
Work holder
Knob
Turn upside down
Work
Table