Instruction manual

- 2.8 -
Setting the work on the machine
Set the work on the table as following.
• Adjust the head height before placing a work on the machine. ( page 2.7)
• Always print on flat works.
• When printing on T-shirts or other cloths, set them flat.
STEPS:
1. Turn on the power to the machine.
2. Adjust the head height. ( page 2.7)
After adjusting, return to the LOCAL mode.
3. Press the [VIEW] key.
4. Push the [VIEW] key or the [ENTER] key.
The table moves toward you.
5. The machine revert the LOCAL mode.
6. Set the work on the marking on the table.
Secure work in such a manner that work can
not float or be dislocated.
<< LOCAL >>
X =1010 Y = 1860
Head Height
∗ ∗ . ∗ mm
VIEW
< ENT >
∗ ∗ VIEW ∗ ∗
<< LOCAL >>
X =1010 Y = 1860