Instruction manual

- 2.7 -
Adjusting the head height
The head can be adjusted in height, according to thickness of a work used for printing.
The head height must be set according to the work thickness. If the head height is too low, it may
affect the printing quality and even damage the work or the machine itself. Be sure that the head
height is correct
• Adjust the head height before setting a work on the machine.
• Leave at least 3mm clearance when printing on T-shirts or other fluffy materi-
als. Otherwise, the head will touch the fluff and affect the print quality.
•Confirm the head height setting value, press the [ENTER] key in the LOCAL,
REMOTE and CYCLE mode. ( page 2.20)
STEPS:
1. The machine enters the LOCAL mode.
Press the [REMOTE] key and put the machine back into the
LOCAL mode.
2. Press the Z [ ] or [ ] keys to adjust the head
height.
The ideal head height is equal to the work thickness + 1.0 to
2.0mm. Check the work thickness before adjusting the head
height.
• If the work thickness is not uniform, use the
work thickness at the thickest point.
3. Press the [ENTER] key.
4. The machine revert the LOCAL mode.
<< LOCAL >>
X =1010 Y = 1860
Head Height
∗ ∗ . ∗ mm
<< LOCAL >>
X =1010 Y = 1860
Head Height
∗ ∗ . ∗ mm