Instruction manual

- 1.12 -
Types of work that can be used
The following describes the sizes of work that can be used and the method of handling.
Sizes of work that can be used
Maximum 1870 mm
Minimum 1050 mm
Max. printing width 1860 mm *
1
Max. printing length 1010 mm
Thickness 50 mm or less
Weight 60kg or less when load is evenly distributed
*1:
When the mode is Discharge Composition printing mode at 720 x 720 variable,
and the product serial number is E1509013 or before, maximum printing width is
1,100 mm.)
Precautions in handling the work
Carefully observe the following when handling the work.
•Work thickness
When setting the work used, adjust the head height.
Otherwise, the work and/or the head can be damaged.
• Expansion and contraction of the work
Do not use sheet types of work immediately after unpacking.
The work can expand and contract due to room temperature and humidity.
The work have to be left in the atmosphere in which they are to be used for
30 minutes or more after unpacked.
•Warps of work
If you want to use board-shaped works, always use flat boards.
• Other tips
• The device has a moving table. The work must be fixed to the table
during operation. If necessary, fix the work with a tape.
• Maintain a sufficient head gap when printing on a fluffy material. If the
print head nozzle is allowed to touch the fluff, it may be blocked and
affect the print quality.