Instruction manual

- 6.6 -
Unidentified Ink
12345678ABCDEFGH
Ink Limit
12345678ABCDEFGH
Ink Color
12345678ABCDEFGH
Ink Type
12345678ABCDEFGH
Ink IC Error
12345678ABCDEFGH
Ink Count Error
12345678ABCDEFGH
Head Height
Check HeadHeight
Check Stop SW or
Station Cover
Service Call
001
Service Call
002
The loaded ink cartridge is not
MIMAKI genuine.
The ink cartridge will expire
soon or has expired.
The color of the loaded ink
cartridge is different from the
previous one.
The type of the loaded ink
cartridge is different from the
previous one.
The IC chip of the ink cartridge
cannot be read normally.
The loaded ink cartridge is
defective.
The head height is incorrect.
The station cover is open or the
stop switch is pressed.
Time to replace regularly
replaceable parts.
Use the ink specified by MIMAKI.
Printing can be continued in file
by-file basis by pressing the
[REMOTE] key. However, it is
recommended that you replace the
ink cartridge is shown on the LCD
with a new one.
Check the color of the loaded ink
cartridge.
Check the type of the loaded ink
cartridge.
Attach the ink cartridge(s) corre-
sponding with the color shown on
the display. If the same error
message appears again on the
LCD, contact your local distributor
to call for service.
Check the loaded ink cartridge.
Correct the head height.
Close the station cover or release
the stop switch.
Contact your local MIMAKI
distributor or call a local MIMAKI
office for services. The parts
may be used until new parts are
delivered.
Warning message Cause Corrective measure
TPig ERROR
12345678ABCDEFGH
TPig ink has been set at the
front side of the carriage in the
initial setting of mixed inks.
Set the TPig ink at the back side of
the carriage.