Operator's Manual

4
3. In mode:
• - In forward,
Mode RPM IPM
1 0-1250 0-900
the tool runs at a re-
duced RPM and then
•
Drive
Control
Button
Mode
Indicators
shuts o ff once the
2 0-1950 0-2100
torque is achieved.
B olt Remov a l - In
3 0-2575 0-3100
reverse, the tool runs at
full RPM and IPM until
the nut breaks free from the joint. Then, the tool
slows to a reduced RPM for better control in
removing the nut.
changing or removing accessories.
WARNING
Always remove battery pack before
ASSEMBLY
WARNING
Recharge
for
onl
the
y with
battery
th
.
e ch
For
arg
spe
er
-
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
reco
Only use
mmended
accessorie
for thi
s
s tool. Others
may be hazardous.
-
cally designed for use on impact wrenches. Other
sockets and accessories might shatter or break
causing injury.
Attaching and Removing Accessories
1/2" Pin Detent
(Cat. No. M18 FMTIW2P12)
1/2" Friction Ring
(Cat. No.M18 FMTIW2F12)
1. Use only the appropriate size Square Drive
Sockets.
2. To attach a socket, align the hole in the accessory
with the detent pin on the anvil. Hold the detent
pin in while pushing the socket onto the anvil.
The detent pin will snap into place in the hole to
secure the socket.
3. To remove the socket, insert a nail or other thin
object into the hole in the accessory and press
1. Use only the appropriate size Square Drive
Sockets.
2. To attach a socket, align the accessory with the
the anvil.
WARNING
Always remove battery pack before
changing or removing accesso-
-
mended for this tool. Others may be hazardous.
Using the Drive Control
The drive control button is used to adjust the torque,
rotation speed (RPM), and impact speed (IPM) for
and IPM).
To select the drive control mode:
1. Pull and release the trigger to turn on the tool. The
current mode indicator is lit.
2. Press the drive control button to cycle through
the 4 modes. When the desired mode indicator is
lit, begin work.
OPERATION
WARNING
To reduce the risk
wear proper eye protection marked
of injury, always
to comply with AS/NZS 1337.1.
When working in dusty situations, wear
appropriate respiratory protection or use a
suitable dust extraction solution.
2
6
5
3
4
FUNCTIONAL DESCRIPTION
7
1. 1/2" Square drive anvil with pin detent
(M18 FMTIW2P12)
2. LED
3. Control switch
4. Trigger
5. 4-Mode drive control
6. Belt clip
7. 1/2" Square drive anvil with friction ring
(M18 FMTIW2F12)
0-2575 0-3100
1