Owner's manual

21
IT62H Integrated Toolcarrier specifications
Operating Specifications
1400
2250 2500 2750 30001500 1750 2000 lb/yd
3
yd
3
m
3
kg/m
3
4.25
5.50
3.25
4.25
1600 18001000 1200
Material Density
Bucket Selection Guide
% = Bucket Fill Factor
115% 100% 95%
Bucket
Size
3.25 4.25 4.25 4.25
4.25 5.50 5.50 5.50
2.61 2.61 2.61 2.61
3.41 3.41 3.41 3.41
2885 2885 2885 2885
9'6" 9'6" 9'6" 9'6"
2785 2730 2730 2840
9'2" 8'11" 8'11" 9'4"
1227 1317 1317 1227
4'0" 4'4" 4'4" 4'0"
2767 2909 2909 2767
9'1" 9'7" 9'7" 9'1"
71 41 71 71
2.80 1.61 2.80 2.80
8498 8649 8649 8498
27'11" 28'5" 28'5" 27'11"
5579 5579 5579 5579
18'4" 18'4" 18'4" 18'4"
6727 6771 6771 6727
22'1" 22'2" 22'2" 22'1"
13 245 12 891 12 734 12 692
29,602 28,425 28,078 27,986
11 730 10 866 10 709 10 689
25,865 23,960 23,613 23,569
159 190 175 176
35,775 42,750 39,375 39,600
19 397 19 179 19 344 19 249
42,770 42,290 42,654 42,444
*S
tatic tipping loads and operating weights shown are based on
standard machine configuration with 23.5R25 tires, full fuel tank,
coolants, lubricants, air conditioner, ride control and operator.
**
Measured 102 mm (4.0") behind tip of cutting edge with bucket
hinge pin as pivot point in accordance with SAE J732C.
(§) Specifications and ratings conform to all applicable standards
recommended by the Society of Automotive Engineers,
including SAE Standard J732C governing loader ratings.
Material Handling Buckets
Bolt-On
Edges Teeth
Teeth and
Segments
Bolt-On
Edges
Bucket
Rated Bucket Capacity (§)m
3
yd
3
Struck Capacity (§)m
3
yd
3
Width (§)mm
ft/in
Dump Clearance at Full Lift mm
and 45° Discharge (§) ft/in
Reach at Full Lift mm
and 45° Discharge (§) ft/in
Reach with Lift Arm mm
Horizontal and Bucket Level (§) ft/in
Digging Depth (§)mm
in
Overall Length mm
ft/in
Overall Height with Bucket mm
at Full Raise ft/in
Turning Radius – Outside Corner of mm
Racked Bucket, Carry Position (§) ft/in
Static Tipping Load Straight * kg
lb
Static Tipping Load kg
Full 40° Turn lb
Breakout Force ** (§)kN
lb
Operating Weight * (§)kg
lb