Assembly Instructions

ManualsBrandsMillwood Pines Manuals5 Piece Kitchen & Dining Room SetsJaiden Wooden 5 Piece Counter Height Dining Table Set

ASSEMBLY RATING

Tools Required For Assembly:







 





O O O





Allen Wrench

Wrench

(Included) �

(Included)

2 PERSONS RECOMMENDED

Page 1 of 7

ssembly Instructions

Summary of content (7 pages)

PAGE 1
Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
PAGE 2
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in an assembly, please make sure the lock or spring washer is placed between the larger flat washer and the head of the screw or bolt. Position each part correctly and insert screws or bolts into their respective holes by hand tighten or using the proper hand tool.
PAGE 3
PAGE 4
Unscrew the screws on the table corner protectors, then take off the corner protectors. Prepare 8 bolts assembly by inserting lock washer (#B), then flat washer (#C) to bolts (#A). Align legs (#2) to the holes of the table top (#1). Secure with bolts (#A).
PAGE 5
PAGE 6
Prepare 2 bolts assembly by inserting lock washer (#E), then flat washer (#F) to bolts (#C). Attach dowel (#G) to the center hole, then align the cushion seat (#2) to the holes of the chair back (#1). Secure with bolts (#C). Prepare 4 bolts assembly by inserting lock washer (#E), then flat washer (#F) to bolts (#A). Secure bottom corner of seat cushion (#2) with bolts (#A).
PAGE 7
1) Prepare 4 bolts assembly by inserting lock washer (#E), then flat washer (#F) to bolts (#B). 2) Align legs (#3L/R) to the holes of the cushion seat, then secure with bolts (#B). Do not tighten bolts. 3) Insert crossbars (#4,5) as shown in the picture. Make sure the screw holes on crossbars are facing at the bottom. 4) Tighten Bolts (#B) attached to legs (#3L/R). Secure crossbars with screws (#H).