Instruction manual

Test and Diagnostic, P900 - P951
These parameter are used for test and diagnostic purposes.
P900 software revision
Displays the EPROM (Flash ROM) software revision level.
P901 memory
Tests the memory. Test is initiated by scrolling to the parameter
or repeated by ’pressing enter’
display:PASS = normal
FAIL = consult Mass Dynamics
P907 programmer interface
Tests the infrared communications link. Test is initiated by scrolling
to the parameter or repeated by ’pressing enter’.
display: PASS = normal
FAIL = consult Milltronics
P911 mA output value
Displays the value from the previous measurement. A test value can be
entered and the displayed value is transmitted to the output. Upon returning
to the run mode, the parameter assumes the actual mA output level.
98\03\09
infrared communication link
mirror
BW100
PARAMETER DESC.
PL-531 73