User's Manual

ManualsBrandsMillitronic ManualsElectronicsPIKA-CONN

User Manual

Wireless screen casting

Windows Computer

HDMI signals

• Step1:

Connect Display and camera by hdmi and usb

cable form PIKA-CONN

• Step2:

Let PIKA-CONN and laptop in the same

wireless area network ( Router)

• Step3:

Laptop connect to Router

• Step4:

Enable Millitronic APP, you can screen cast to

display, and turn on the web cam

Display monitor

Web

Cam

USB signals

Caution:

GHz band (W52): Indoor use only (except

communicate to high power

radio)

W52屋内使用限定ただし登録局に

接続

される

場合は除く

Summary of content (5 pages)

PAGE 1
User Manual Web Cam • Step1: Connect Display and camera by hdmi and usb cable form PIKA-CONN • Step2: Let PIKA-CONN and laptop in the same wireless area network ( Router) HDMI signals USB signals Display monitor • Step3: Laptop connect to Router • Step4: Enable Millitronic APP, you can screen cast to display, and turn on the web cam Wireless screen casting Caution: - 5GHz band (W52): Indoor use only (except communicate to high power radio) - W52屋内使用限定ただし登録局に接続される場合は除く Windows Computer © 2020 MILLIT
PAGE 2
• Federal Communication Commission Interference Statement • This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
• IMPORTANT NOTE: • This module is intended for OEM integrator. This module is only FCC authorized for the specific rule parts listed on the grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification. The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.
PAGE 4
• USERS MANUAL OF THE END PRODUCT: • In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the antenna while this end product is installed and operated. The end user has to be informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be satisfied.
PAGE 5
• LABEL OF THE END PRODUCT: • The final end product must be labeled in a visible area with the following " Contains TX FCC ID: 2AJAS9WPIKA010901". • • This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. • Ant List Gain (dBi) Ant.