User manual

General information, Continued

READY Mode

– water quality

values

x The READY Mode screen display is explained below.

x This screen shows the resistivity and temperature of the water filling the

Reservoir.

x The Reservoir water is further purified and dispensed from the Q-POD Unit.

x The Q-POD Display shows the quality of this water.

READY Mode screen Explanation

In this example, the water filling the

Reservoir has:

x a resistivity of 12.5 M:.cm,

x is temperature compensated,

x a temperature of 25.1°C, and

x the Reservoir is 80% full.

NOTE:

When the Milli-Q System stops

filling the Reservoir, the last

measurements of water quality are

displayed.

x In this example, the Milli-Q

System was powered on but did

not begin to fill the Reservoir.

x In this case, there are no water

quality measurements to display.