User manual

56
Registering <Examine Inlet Strainer> message timer
Introduction
x The timer used for cleaning the Inlet Strainer must be reset when the
Milli-Q System is installed.
x If this is not done, then the message indicating that the message Examine
Inlet Strainer is shown too early.
Procedure
This procedure shows how to reset the timer used for the message Examine
Inlet Strainer.
Step Action Diagram
1 Start in STANDBY Mode.
2
x Select <Menu>.
x Press
.
3
x Select <Maintenance>.
x Press
.
4
x Select <Clean Strainer>.
x Press
.
Continued on next page