User manual

Installing the Progard Pack

Procedure

x Follow the steps below to install a new Progard Pack.

x After the Progard Pack is installed, the Milli-Q System starts an automatic

flush.

x During Milli-Q System installation procedure, the automatic flush is

cancelled.

x During the regular maintenance of the Milli-Q System, the automatic flush

is not cancelled.

Step Action Diagram

1 Start in STANDBY Mode.

NOTE:

The PROGARD PACK OUT

Alarm message is not shown at

this time. By following the

instructions earlier in this

manual, the alarm was

cancelled.

x Open the left door of the

Milli-Q System Cabinet.

x Remove the 2 protective caps

located on the ports inside.

Continued on next page