User manual

31
Alarms generated during installation
Overview
x During the installation of a Milli-Q System, certain Alarm messages are
generated.
x This occurs because:
 the Reservoir is empty,
 there is air in the tubings and in the Progard Pack,
 the Progard Pack is not installed,
 the Quantum Cartridge is not installed, and
 an automatic flush of the Progard Pack is manually cancelled.
x These alarms are explained here. The ways to cancel them are explained
also. For more information about Alarm messages, see the chapter titled
‘Alarms’.
x It is perfectly normal to see alarms during installation.
x The Milli-Q System is designed to use various sensors to alert you of
problems during normal operation of the system. This insures optimal
water quality.
x During installation, these sensors are active. As a result, it is possible to
have alarms generated. In order to advance during the installation, these
alarms should be cancelled.
TANK EMPTY
message
x This alarm occurs because the Reservoir is empty during most of the
installation.
x This alarm goes away when the Reservoir is partially full.
x To cancel the text display of this alarm message, follow the instructions on
the LCD.
PROGARD
PACK OUT
message
x This alarm occurs because the Progard Pack is not installed.
x This alarm goes away when the Progard Pack is detected by the Milli-Q
System.
x To cancel the text display of this alarm message, follow the instructions on
the LCD.
QUANTUM
CARTRIDGE
OUT message
x This alarm occurs because the Quantum Cartridge is not installed.
x This alarm goes away when the Quantum Cartridge is detected by the
Milli-Q System.
x To cancel the text display of this alarm message, follow the instructions on
the LCD.
Continued on next page