User manual

30
Installation
Overview
Purpose
This chapter explains how to install the Milli-Q System.
Contents
This chapter contains the following topics:
Topic See Page
Alarms generated during installation 31
Q-POD Unit 34
Main Cabinet tubings, cables and power cord 37
Installing the Quantum Cartridge 40
Installing the Progard Pack 42
Rinsing the RO Cartridges 45
Rinsing the Quantum Cartridge 48
Installing a POD Pak 51
Registering UV Lamp timers 54
Registering <Examine Inlet Strainer> message timer 56
Calibrating the Flowrate 58
Cleaning the A10 TOC Monitor 61
Summary list
The steps shown below outline the sequence and major actions of a Milli-Q
System installation. Please refer to this list throughout the installation.
Step Action
1 Assemble the Q-POD Unit
2 Connect the RC-Link to the Q-POD Unit
3 Install Milli-Q Cabinet tubings, cables and power cord
4 Power on the Milli-Q System
5 Install the Quantum Cartridge
6 Install the Progard Cartridge
7 Flush and rinse the RO Cartridge(s)
8 Fill the Reservoir
9 Flush and rinse the Quantum Cartridge
10 Install and Register the POD Pak
11 Register the UV Lamp timers
12 Register the timer for the EXAMINE INLET STRAINER
message
13 Calibrate the Product Water flowrate
14 Clean the A10 TOC Monitor