User manual

MAINTENANCE

- 59 -

NSTALLING THE NEW UV LAMP

 Ensure that you use the gloves supplied with the

UV replacement kit. Plug the electrical cable to

the new UV Lamp (G).

 Carefully insert the UV Lamp into the UV

housing (H).

 Attach the UV housing with the Velcro belt (I).

 Install the SmartPak (J).

 Install the Final Filter.

If the SmartPak is not being replaced, then

reinstall the old SmartPak BEFORE powering ON

the system. Otherwise, the system will go into

FLUSH mode for 15 minutes during which no

Product Water will be available.

 Close the front cover.

 Plug the electrical cord to power ON the system.

 Reset the UV Timer. See Section 6-10 How to

View or Reset the UV Lamp Timer (C05).

ATTENTION