User manual

INSTALLATION

- 18 -

4-7 PURGING AIR FROM THE SYSTEM

 At this time you should have installed the

SmartPak, Barbed Fitting and the Tygon

Tubing. Air trapped in the SmartPak should now

be purged from the system.

 Verify that you have a full tank of RO water by

viewing the Tank Level display (A).

 Press the Dispensing Button once to put the

system into DISPENSING mode (B).

 Dispense the full tank of water from the system.

 The system will go into FILLING TANK mode

when the tank level is below the 60% level (C).

 When the tank level reaches the minimum level,

the system will finish dispensing water.

4-8 HYDRATING THE SYSTEM

 At this time, the Final Filter is not installed.

Leave the system overnight or for several hours

in FILLING TANK mode or PRE OPERATE

mode (see Section 5-3 Operating Modes). The

system will regularly recirculate water and rinse

off purification media inside the SmartPak. Do

not leave the system in STANDBY mode.

 (The next morning) Press the Dispensing Button

once to put the system into DISPENSING mode.

 Allow about 1 Litre of water to be dispensed

from the system.

 Press the Dispensing Button once again. The

system will finish dispensing water.

 Remove the Tygon Tubing and the Barbed

Fitting from the POU Dispenser.

The Final Filter needs to be installed. See Section 4-9

Installation and Rinsing of the Final Filter.