User manual

INSTALLATION
- 13 -
4-3 CONNECTION OF THE POWER CORD − TURNING ON THE SYSTEM
POWER
 Open the front cover of the system (A). This
will allow the system to go into STANDBY
mode once the system is powered.
 Plug the Power Cord into the system (B).
 Plug the other end of the Power Cord into an
appropriate source of electrical power (i.e. wall
outlet). The system is immediately powered.
 Open the Feedwater Supply Valve.
S
TART-UP DISPLAYS
Once the system is powered, the system will start to
display information about the software before going
into STANDBY mode (C).
A
B
C