Specifications

Heavy-Duty Hydraulic Cylinders
HV2 Series
Catalog HY08-M1140-3/NA
72
www.milleruidpower.com
Miller Fluid Power
Des Plaines, IL
Milton, Ontario Canada
How to Order HV2 Series Cylinders
Data Required On All Cylinder Orders
When ordering HV2 Series cylinders, be sure to specify each of the following requirements:
(NOTE: – Duplicate cylinders can be ordered by giving the SERIAL NUMBER from the original cylinder. Factory records
supply a quick, positive identication.)
a) Series Designation (“HV2”)
b) Mounting Model
Specify your choice of mounting – as shown
and dimensioned in this catalog.
c)
Bushing Style “B” or “R” – Bronze
“I” or “N” – Iron
d) Piston Rod End Thread Style
Call out thread style number.
Thread style 2 will be furnished if not otherwise
supplied. For special rod ends specify style “X”
as indicated below.
e) Cushions (if required)
Specify “Cushion-head end,” “Cushion-cap end” or
“Cushion-both ends” as required. If cylinder is to
have a double rod and only one cushion is
required, be sure to specify clearly which end of
the cylinder is to be cushioned.
f) Bore Size
g) Length of Stroke
h)
Piston Rod Diameter
Call out rod diameter. In HV2 Series cylinders,
standard rod diameters will be furnished if not
otherwise specied, unless length of stroke makes
the application questionable.
i) Ports
SAE straight thread is standard.
j)
Port Locations
k) Seals
l) Modications
Any modications that are not identied in the
cylinder number shown on the following page
should be added to the specications. These can
include special uids, special seals, air bleeds,
double rod cylinder with dierent rod end styles
and diameters. For further information consult
factory.
Service Policy
When cylinders are returned to the factory for repairs, it is
standard policy for Miller Fluid Power to make such part
replac
ements as will put the cylinder in as good as new
condition. Should the condition of the returned cylinder be
such that expenses for repair exceed the cost of a new one,
you will be notied.
Certied Dimensions
Miller Fluid Power guarantees that all cylinders ordered from
this catalog will be built to dimensions shown. All dimensions
are certied to be correct, and thus it is not necessary to
request certied drawings.
Style X Rod End
A style X rod end indicates a special rod end conguration.
All special rod ends must be described by at least all three:
KK; A; or W/WF specied with the rod fully retracted. A
sketch or drawing should be submitted for rod ends requiring
special machining such as snap ring grooves, keyways,
tapers, multiple diameters, etc. It is good design practice to have
this machining done on a diameter at least 0.065 inches smaller
than the piston rod diameter. This allows the piston rod to have
a chamfer preventing rod seal damage during assembly or
maintenance.
Model Numbers