Owner`s manual

. A complete Parts List is available at www.MillerWelds.com

OM-237 974 Page 19

5-2. Mild Steel Recommended Cut Speed

. Aluminum and stainless steel cut speeds at these thicknesses may be reduced as much as 30%.

Thickness Approximate Travel Speed*

Inches Millimeters IPM mm/min

1/8 3.2 149 3785

1/4 6.4 60 1524

3/8 9.5 34 864

1/2 12.7 21 533

5/8 15.9 12 305

*Travel speeds are approximately 80% if maximum. The best cut quality is achieved by cutting near the table value. Cutting below the value

(too slow) will result in excess dross. Cutting above the value (too fast) will cause blowback and lack of penetration.

5-3. Trigger Safety Lock

Trigger Locked Trigger Unlocked

1 Trigger

802 877