Owner`s manual

OM-172 324 Page 66
SECTION 12 – MAINTENANCE & TROUBLESHOOTING
12-1. Routine Maintenance
Turn Off all power before maintaining.
3 Months
OR
Blow Out
Or
Vacuum
Inside
Replace
Unreadable
Labels
6 Months3 Months
Tape Or
Replace
Cracked
Weld
Cable
14-Pin Cord
Gas Hose Gun Cable
Replace
Cracked
Parts
During Heavy Service,
Clean Monthly
12-2. Overload Protection
Turn Off robot, interface, and weld-
ing power source.
1 Circuit Breaker CB1
CB1 protects the interface from
overload. If CB1 trips, the unit shuts
down.
Allow cooling period and manually
reset breaker.
2 Fuse F1
F1 protects the interface from over-
load. If F1 opens, the unit shuts
down.
Replace F1 with fuse of the same
type, size, and rating.
ST-800 962-A
1
2