Owner`s manual

OM-172 324 Page 61
10-17.Selecting Program Name Feature
1 Name Display
When a data card is used, the pro-
grams written from the unit to the
card can be named.
Memo r y
Shu t down
>N a m e
Program
Ca r d
Pr o g r a ms
>O n
Ca r d
Pr o g r a ms
>O f f
Increase
1
Press
Mode Select
Access
Setup
Display
10-18.Remote Program Select
Remote Program Select is in binary code, with “A” the least significant bit, and “C”
the most significant bit.
NOTE
1 Program Display
When Program is On, a remote de-
vice may be used to select pro-
grams. When Off, program selec-
tion must be done from robot Teach
Pendant or interface pulse panel.
Shu t down
Name
>P r o g r a m
St ick
Rem o t e
Pr o g r a m
>O ff
Rem o t e
Pr o g r a m
>O n
Increase
1
Press
Mode Select
Access
Setup
Display
10-19.Stick Check Selection
1 Stick Check Display
When stick check is On, a stick
check routine is performed at the
end of each weld. When Off, no
stick check is done.
Name
Program
>S t i c k
Jog IPM
St i c k
Ch e c k
>O n
St i c k
Ch e c k
>O ff
Increase
1
Press
Mode Select
Access
Setup
Display