Owner`s manual

OM-172 324 Page 60
10-15.Resetting Memory
1 No Reset
Memory cannot be reset.
2 Program Reset
Press Parameter Select button to
reset last active program to original
factory program settings. All other
program and setup information re-
mains the same.
3 System Reset
Press Parameter Select button to
reset programs and setup to origi-
nal factory settings. System, Arc
Time, and Model Type settings are
not affected by the system reset.
4 Reset (Default) Displays
Wi re t ype
Display
>Me m o r y
Shu t down
>N o R e s e t
>P r o g r a m 1
Rese t
Press
>P r o c e s s
Sequence
Ca r d
>P r g 1
Pu l se
035” Steel
Argon Oxy
Increase/
Decrease
1
2
4
Parameter
Select
Press
Mode Select
Access
Setup
Display
>S y s t e m
Rese t
Press
Increase/
Decrease
3
Parameter
Select
10-16.Selecting Arc Start/Volt Sense Error Shutdown
1 Voltage Shutdown Display
With Arc Start/Volt Sense on, the
unit shuts down when no arc volt-
age is sensed. If the unit shuts
down, an error message appears
(see Section 12-3).
With Arc Start/Volt Sense off, the
unit continues to feed wire even
when there is no arc voltage
sensed.
Display
Memo r y
>S h u t d o w n
Name
Ar c S t a r t /
Vo l t S e n s e
>O n
1
Ar c S t a r t /
Vo l t S e n s e
>O f f
Increase
Press
Mode Select
Access
Setup
Display