Owner`s manual

OM-172 324 Page 59
10-13.Selecting Wire Type
If wire type is changed, perform a memory reset (see Section 10-15) immediately
after selecting wire type to bring up the correct welding programs.
NOTE
1 Wire Type Display
Select soft wire when using alumi-
num wire in the wire feeder. Select
hard wire when using any other kind
of wire.
Wi re Type
In Feeder
>H a r d w i r e
Increase
1
Press
Mode Select
Access
Setup
Display
Arc Time
Wi refeed
>W i r e t y p e
Display
Wi re Type
In Feeder
>S o f t w i r e
10-14.Selecting Display
1 Display Select Display
The display can show amps, actual
reading or print out command.
1
Wi refeed
Wi re t ype
>Di s p l a y
Memo r y
Command
Amp s
Increase
Press
Mode Select
Access
Setup
Display
Ac tua l
Increase