Owner`s manual

OM-172 324 Page 57
10-9. Selecting Voltage Sensing Method
1 Voltage Feedback Display
When using the 17 Pin setting, arc
voltage feedback is through the
welding power source and the feed-
back signal is sent through the
17-pin cord to the feeder.
If the 17 Pin setting is used, it is rec-
ommended that the voltage sens-
ing terminals on the welding power
source be used to monitor arc volt-
age at the workpiece.
When using the V. Sense setting,
arc voltage feedback is through the
voltage sense leads connected to
the feeder. Use this setting when
there is more than 50 ft (15 m) of
weld cable used.
Induc t .
Pu r ge
>Vo l tage
ArcStar t
Co n t r o l
Feedback
>1 7 P i n
1
Co n t r o l
Feedback
>V . S e n s e
Increase
Press
Mode Select
Access
Setup
Display
10-10.Selecting Arc Start Method
Arc Start selection is not used when welding in non-pulsed MIG.
Do not use the Hot Start setting for .035 in (9 mm) or smaller wire.
NOTE
Ar c S t a r t
Ty p e
>H o t S t a r t
1 Arc Start Display
Use the Hot Start mode for pulse
welding with 450 Ampere Inverter
Model when high initial weld current
is necessary to start large diameter
welding wires. When in Hot Start,
the 450 Ampere Inverter Model
starts the arc in the CV mode and
switches to CC once the arc is
started. Do not use Hot Start unless
using 450 Ampere Inverter Model.
1
Increase
Pu r ge
Vo l tage
>A r c S t a r t
Arc Time
Pu l se
Ar c S t a r t
>S t a n d a r d
Ar c S t a r t
Ty p e
>S o f t S t a r t
Press
Mode Select
Access
Setup
Display