Owner`s manual

OM-172 324 Page 56
10-6. Selecting Voltage Correction
1 Mig Type Display
With DVC Voltage Correction On,
the unit uses closed-loop feedback
from the 17-pin cord or voltage
sensing leads to maintain set volt-
age parameters.
With DVC Voltage Correction Off,
feedback from the arc is not used
for closed-loop feedback to main-
tain voltage parameters. Feedback
from the arc is still used for other
functions.
Be sure voltage sensing leads are
connected or voltage feedback is
available through the 17-pin recep-
tacle via the welding power source.
1
Increase
Vo l t age
Co r r e c t i o n
>D V C O n
Secu r i t y
Access
>M i g T y p e
Induc t .
Vo l t age
Co r r e c t i o n
>D V C O f f
Press
Mode Select
Access
Setup
Display
10-7. Selecting Inductance
1 Inductance Display
The inductance level can be varied
between 0 (zero) and 99.1
Increase
Ac c e s s
Mig Type
>Induc t .
Pu r ge
Le v e l
30
Le v e l
99
Press
Mode Select
Access
Setup
Display
10-8. Selecting Purge Time
1 Purge Display
The purge time can be varied be-
tween 0.0 (zero) and 25.0 seconds.1
Increase
Mig Type
Induc t .
>P u r g e
Vo l t age
Ti me
0.0
Ti me
25.0
Press
Mode Select
Access
Setup
Display
Use Purge only when a weld
program is not running.