Owner`s manual

OM-172 324 Page 55
10-5. Selecting Or Changing Access Code
Access code works only when a data card is inserted (see Section 9).
NOTE
1 Code Display
With code off, access to the setup
displays is not restricted.
With code on, the operator must
know and enter the access code to
access or change any of the setup
displays.
2 Access Display
With a code set, this display ap-
pears when power is turned on
while holding the pulse panel Mode
and Parameter Select buttons.
Press Parameter Select button to
enter access code. When the cor-
rect letter is entered, the indicator
automatically moves to the next
character. When the final access
code letter is entered, the display
automatically changes to the initial
setup display.
1
Parameter
Select
Range
Secu r i t y
>A c c e s s
Mig Type
Co d e
>O f f
Code
>O n
AAA
Co d e
On
>A AA
⇒Press
Co d e
On
>Z WX
⇒Press
En t e r
Access
Code
>Code AAA
⇒Press
Increase
Increase/Decrease
To Set Code
Parameter Select
To Move
2
Turn Power Off And Back On
And Access Security Display
Press Mode
Select
Access
Setup
Display
Indicator