Owner`s manual

OM-172 324 Page 53
10-3. Selecting Welding Power Source Range
Welding power source minimum and maximum voltage values are always
required. Amperage values are required for pulse welding.
NOTE
1 Range Display
See welding power source Owner’s
Manual for voltage and amperage
ranges. Set values to match weld-
ing power source ranges.
2 Minimum Voltage Display
Range is 0 to 25.0 volts.
3 Maximum Voltage Display
Range is 25.0 to 99.9 volts.
4 Minimum Amperage Display
(Available When System Set
For Pulse/Mig)
Range is 0 to 50 amperes.
5 Maximum Amperage Display
(Available When System Set
For Pulse/Mig)
Range is 150 to 999 amperes.
1
Access
Setup
Parameter
Select
Press Mode
Select
>Range
Secu r i t y
Access
Mig Type
>V o l t M i n
10.0Vo l t
>V o l t M a x
38.0Vo l t
Vo l t Mi n
>1 0 . 0 Vo l t
Vo l t Mi n
>8. 0 Vo l t
Increase
Increase/Decrease
2
Display
Parameter
Select
Parameter
Select
>A m p M i n
10 Amp
3*
4*
Parameter
Select
>A m p M a x
565 Amp
5*
Default values are for 450 Ampere Inverter Model.
Do not change values if using 450 Ampere
Inverter Model.
*Use Parameter Select button to
select voltage or amperage.
Use Increase/Decrease buttons
to change value.