Owner`s manual

OM-172 324 Page 51
SECTION 10 – SETUP
10-1. Setup Flow Chart
>Memory No Reset 10-15
Program Reset
Memory Reset
>Wiretype Wire Type Hardwire/Softwire 10-13
In Feeder
>Arc Start Arc Start Type Standard 10-10
Hot Start
Soft Start
>Monitor Arc Volt Error Off/On 10-22
Range 0.1 - 9.9
Sec 0.1 - 25
>Program Remote Off/On 10-18
Program
>Shutdown Arc Start/ Off/On 10-16
Volt Sense
>Display Actual 10-14
Amps
Command
>Security Program Number 10-4
Lock Off/On
>Access Code Off/On 10-5
Display Features Settings Section
Selection
>Mig Type Voltage DVC On/Off 10-6
Correction
>Voltage Control 17-Pin 10-9
Feedback Volt Sense
>Arc Time Run Hours 0–9999.99 Hours 10-11
0–999,999 Cycles
No Reset
Reset
1 Display Selections
2 Features
3 Settings
To set up features that customize
operation, use the setup displays.
Features that can be customized
are as follows:
>Range
Secu r i t y
Access
Mig Type
Vo l t Mi n
10.0 Vo l t
Example Of Pulse Panel Setup Display
1
Display Features Settings Section
Selection
>Software Version Number 10-23
>Robot 10-21
>Name Card Programs Off/On 10-17
>Wire Feed Display IPM/MPM 10-12
Motor Type Standard
Low Speed
High Speed
>Inductance Level 0.0 - 99 10-7
Press Mode Select
To Go To Next Set-
up Display
>Range Volt Min 0.0 - 25.0 V 10-3
Volt Max 25.0 - 99.9 V
Amp Min 0 - 50 A
Amp Max 50 - 999 A
>Purge Button 0.0 - 25.0 10-8
Timer
>Stick Stick Check Off/On 10-19
>Jog IPM IPM 50 - 780 10-20
2
3