Owner`s manual

OM-172 324 Page 49
9-4. Reading From Card
Use Mode Select button to select
Card.
1 Card Display
2 Moving Line
Moving line is under value that can
be changed. Use increase or de-
crease button to select program
number to read from card to feeder.
3 Read Display
Use increase or decrease button to
select feeder program number
where the card program goes.
Process
>C a r d
Sequence Press
Be l ow
#1Pu l se
035” Steel
Argon– Oxy
Press
1
2
3
Read Card
to Feeder
Prg 1
Press
WARN I NG : Prg1 Will
Be Los t
Lose? Ye s
Press
Prg1 Will
Be Los t
Lose? No
Press
Read Done
Ca r d P r g1
to Prg 1
Press
#1Pu l se
035” Steel
Argon– Oxy
Press
#1Pu l se
035” Steel
Argon– Oxy
Press
Wr i t e
>Read
De l e t e
Done
Increase
Parameter
Select
Parameter
Select Once
Mode
Select
Twice
Parameter
Select
Parameter
Select
Parameter
Select
Parameter
Select
Yes
No
9-5. Reading (Or Deleting) From An Empty Card
1 Warning Display
If there are no programs on the
card, this series of displays appear.
Wr i t e
>Read
De l e t e
Done
WARN I NG :
Ca r dEmp t y
Press
Be l ow
Wr i t e
Read
De l e t e
>Done Press
>P r o c e s s
Ca r d
Sequence
>P r g 2
MIG
1
Parameter
Select Once
Parameter
Select