Owner`s manual

OM-172 324 Page 45
D. Setting Crater Sequence Display
1 Crater Parameters Display
Parameter ranges are as follows:
Seconds, 0-2.50 Sec. If value set is
zero (0), there is no Crater
sequence.
Volts, 10.0-38.0 Volts.
Wire Feed Speed, 50 to 780 inches
per minute, IPM.
Go to Section 8-3E.
Parameter
Select
>C r a t e r
0.02Sec
24.0Vo l t
90 IPM
Crater
0.12Sec
>1 8 . 0 Vo l t
90 IPM
Set Desired
Increase/
Decrease
Parameter
Select
Set Desired
Increase/
Decrease
Crater
0.12Sec
18.0Vo l t
>2 0 0 IPM
Set Desired Time
Increase/
Decrease
Crater
>0 . 12Sec
24.0Vo l t
90 IPM
Parameter
Select
Proceed to next figure.
Increase
>C r a t e r
0.12Sec
18.0Vo l t
200 IPM
Wire Feed Speed
Voltage
Parameter
Select
1
E. Setting Burnback Sequence Display
1 Burnback Parameters Display
Parameter ranges are as follows:
Volts, 10.0-38.0 Volts
Seconds, 0-0.25 seconds. If value
set is zero (0), there is no Burnback
sequence.
Go to Section 8-3F.
1
Parameter
Select
>B u r n b a c k
0.00 Sec
18.0 Vo l t
Burnback
0.12 Sec
>1 6 . 0 Vo l t
Set Desired
Increase/
Decrease
Set Desired Time
Increase/
Burnback
>0 . 1 2 Sec
18.0 Vo l t
Burnback Volts
Proceed to next figure.
Increase
>B u r n b a c k
0.12 Sec
16.0 Vo l t
Parameter
Select
Parameter
Select
Decrease