Owner`s manual

OM-172 324 Page 44
B. Setting Start Sequence Display
1 Start Parameters Display
Parameter ranges are as follows:
Seconds, 0-2.5 Sec. If value set is
zero (0), there is no Run-In
sequence.
Volts, 10.0-38.0 Volts
Wire Feed Speed, 50-780 inches
per minute, IPM
Go on to Section 8-3C.
1
Set Desired Voltage
Increase/
Set Desired
Increase/
Decrease
Set Desired Time
Increase/
Decrease
>S t a r t
0.2 Sec
24.0Vo l t
90 IPM
Star t
0.5 Sec
>1 8 . 0 Vo l t
90 IPM
Star t
0.5 Sec
18.0Vo l t
>2 0 0 IPM
Star t
>0 . 5 Sec
24.0Vo l t
90 IPM
Decrease
Parameter
Select
Wire Feed Speed
Parameter
Select
Parameter
Select
Parameter
Select
>S t a r t
0.5 Sec
18.0Vo l t
200 IPM
Increase
Proceed to next figure.
C. Setting Weld Sequence Display
1 Weld Parameters Display
Parameter ranges are as follows:
Volts, 10.0-38.0 Volts
Wire Feed Speed, 50-780 Inches
Per Minute, IPM
Go to Section 8-3D.
Parameter
Select
We l d
20.0Vo l t
>2 0 0 IPM
Set Desired Wire Feed Speed
Increase/
Decrease
>We l d
20.0Vo l t s
420 IPM
Proceed to next figure.
Increase
1
We l d
>1 8 . 0 Vo l t
200 IPM
Increase/
Decrease
Set Desired Voltage
Parameter
Select