Owner`s manual

OM-172 324 Page 43
8-3. Setting Sequence MIG Welding Parameters
Control circuit and interface operational power are On
when using or changing the microprocessor settings.
A. Setting Preflow Sequence Display
1 Pulse Panel Display
When unit is turned On, Process is
the default mode. Use mode select
button to select Sequence.
2 Parameter Select Button
Use parameter select button to se-
lect parameters.
3 Preflow Parameters Display
Preflow can be adjusted from 0-9.9
seconds. If value set is zero (0),
there is no Preflow sequence.
Go to Section 8-3B.
3
Set Desired Time
Increase/
Decrease
Proceed to next figure.
Pref low
>0 . 0 Sec
>P r e f l o w
1.2 Sec
Increase
Parameter
Select
Parameter
Select
2
Process
Ca r d
>Sequence
Mode
Select
1
>P r o c e s s
Ca r d
Sequence
>P r g 1
MIG
>P r e f l o w
0.0 Sec