Owner`s manual

ROBOTIC INTERFACE II SET-UP INFORMATION
Please fill out the following information when setting up your equipment. It can be used for your records and also
be valuable if you ever need to call for service.
Model: ROBOTIC INTERFACE II,Serial Number:
Software Version
SET-UP INFORMATION (found in set-up menu)
Range: min V Shutdown:  off  on
max V Program Remote Select:  off  on
min A
max A
Security:  off  on Stick Check:  off  on
Access:  off  on Jog IPM:
Mig Type: dvc  off  on Robot:  total control  power source,
wire gas, and analog
 Arc on and analog
 Arc on and no analog
Inductance: Monitor Arc Voltage Error:  off  on
Range
Seconds
Purge: Voltage:  17 pin  Vsense
Arc Start:  standard  hot Arc Time:
Wire Feed:  ipm  mpm Wire Type:  hardwire  softwire
Display:  actual  amps
 command
OTHER IMPORTANT INFORMATION
Wire Size: Type: Gas:
Program#:  factory  custom
Mig or Pulse: Wire Speed: Voltage/Trim: Travel Speed:
Weld Cable Size: Approx. Length:
Material Type: Thickness: Type of Joint: